Industrial heat pumps: recovering waste heat
An industrial heat pump captures heat at low temperature, often waste heat, and delivers it at a level useful to the process. It advantageously replaces a fossil boiler when the temperature lift to bridge stays moderate.
What determines performance
- Temperature lift between source and use: the smaller it is, the higher the coefficient of performance (COP).
- Typical COP: around 3 to 5 for lifts of 40 to 60 K, roughly half the theoretical Carnot COP.
- Price ratio between electricity and gas, which decides profitability as much as technology.
- Output temperature: commercial offers commonly reach 120 to 150 °C; beyond that, solutions are at demonstration stage.
Choice of fluid and source
Ammonia, hydrocarbons, CO₂ and new-generation HFO-type fluids share the market; the F-gas Regulation (EU) 2024/573 progressively phases down high-warming-potential fluids. Typical sources are cooling water, condensates, compressed air, process discharges between 30 and 80 °C or treated effluents.
Integration in the site
A typical project compares the levelised cost of heat produced with the existing solution, includes the carbon price and available aid, then tests sensitivity to energy prices. Production stops, exchanger fouling and compressor maintenance must be included in the file.
- Place the heat pump according to pinch analysis, on both sides of the pinch.
- Combine with thermal storage to absorb gaps between source and demand and shift electricity use.
- Size supply and connection with electrical energy conversion to avoid contracted-power surcharges.
- Simulate the whole on a digital twin before ordering.
Tracking indicators
Track real COP over the year, not just at nominal point, the share of heat covered, operating hours and availability. These indicators feed the site’s energy management plan and justify any capacity extension.
Key takeaway: the best heat pump project starts with the best heat-recovery project. Reduce demand, match source and sink temperatures carefully, and design controls that keep the COP high throughout the year.
Going further
- Pinch analysis and heat integration
Pinch method: composite curves, ΔTmin, golden rules and retrofit to reduce a process’s heating and cooling consumption.
- Electrical energy conversion devices
Power electronics, inverters, DC/DC converters, silicon carbide and gallium nitride for electrical energy conversion.
- Industrial thermal storage: sensible, latent, salts
Sensible, latent and thermochemical storage: sizing, losses, industrial uses and coupling with heat pumps and renewables.
- Model predictive control (MPC) of energy processes
Principle of model predictive control, energy gains, prerequisites, cybersecurity and implementation on utilities and processes.
- Energy systems optimisation
Pinch analysis, heat recovery, high-temperature heat pumps, thermal storage and predictive control for industrial energy systems.