GtProcess

Thermal storage: shifting heat to smooth peaks

Thermal storage accumulates heat or cold to release it later. It is generally cheaper per kWh than electrochemical storage, provided the final need is thermal.

Updated on

Three technology families

  • Sensible: hot or pressurised water, oils, concrete, molten salts, depending on temperature from 60 to over 500 °C.
  • Latent: phase-change materials, storing much energy at nearly constant temperature.
  • Thermochemical: reversible reactions with high energy density, still at demonstration stage.

Industrial use cases

  • Decouple a heat pump from demand to consume off-peak or when renewable power is available.
  • Shave steam demand and reduce boiler size.
  • Valorise intermittent waste heat found by pinch analysis.
  • Store solar thermal energy or electricity turned into heat.

Sizing and losses

Sizing starts from hourly load curves and the price profile. Storage duration, release temperature and number of cycles must be set. Heat losses depend on insulation, surface and storage time; they stay low for daily cycles and penalising for seasonal storage.

Thermal storage only makes sense if controlled: a predictive control algorithm anticipates needs and prices to decide when to charge. For an electrical need, compare with electrical storage, whose efficiency and cost per kWh differ.

Example of reasoning

Take a site with very irregular steam demand and two-hour peaks. Rather than sizing the boiler on the peak, a storage tank smooths demand and allows a smaller machine, running longer at better efficiency. Savings come from both investment and fuel use. Finally check pressure-equipment safety, material resistance to thermal cycling, corrosion and compatibility with process fluids before ordering.

Key takeaway: thermal storage is the cheapest flexibility available to industry. Combined with heat pumps and smart controls, it turns variable electricity prices and renewable output into an economic advantage for the site. Remember to plan insulation quality, inspection access and a clear operating strategy, because most disappointing installations suffer from weak control rather than from the storage medium itself, and these points are inexpensive to address at design stage.

Going further