GtProcess

Process intensification: doing more with smaller equipment

Process intensification covers equipment and methods that raise output sharply per unit of volume: compact reactors, combined functions and better heat and mass transfer. It reduces energy use, footprint and the amount of hazardous material held on site.

Updated on

Main technologies

  • Microreactors and continuous-flow reactors: very high exchange surfaces, control of exothermic reactions and faster scale-up from lab to production.
  • Reactive distillation: reaction and separation in one unit, removing process steps.
  • Dividing-wall columns: separate three fractions in a single column, often saving around 20 to 30 % of energy.
  • Compact heat exchangers: welded-plate or printed-circuit designs recover heat at small temperature differences.
  • Membrane processes: replace some distillation or evaporation steps with less energy-intensive separation.

Expected benefits

A smaller inventory improves inherent safety: less material means limited consequences in an incident. Compact equipment also cuts heat losses, residence times and civil works. In fine chemicals and pharmaceuticals, continuous flow improves batch quality and reproducibility.

Limits and approach

Solids, fouling and scale-up remain the main obstacles: a microchannel clogs faster than a tank. Start with a mass and energy balance, then simulate on a digital twin and run pilot trials. Thermal gains combine with pinch analysis and process electrification to reach maximum sobriety. Appraise the investment with the method in energy investment valuation.

Where to start

Identify the step that dominates energy use or risk: a large column, a batch reactor, a fouled exchanger. Quantify the potential gain of an intensified technology on that specific item, then launch a short pilot. This targeted approach limits technical risk and quickly yields feedback to decide on wider deployment.

Typical sectors and results

Refining, bulk and fine chemicals, pharmaceuticals and food processing all report gains, usually in three areas: lower specific energy, smaller plant footprint and fewer by-products. Results depend on how well the technology matches the chemistry and the solids content, so a laboratory demonstration under realistic feed conditions should always precede any purchase decision.

Involve operations and maintenance early: compact equipment is harder to clean and inspect, and operator acceptance conditions long-term performance.

Going further